Instructions for assembling PET packaging with a handle for three frames.

Before directly assembling the container, we recommend that all bends be ironed in advance. This will simplify the assembly.

This is what an unassembled container looks like.

We smooth out all the bends.

We bend the protective "flaps" as shown in the picture.

We bend the special locks as shown in the picture.

We expose the sides

We expose the bottom side.

We lock the front side of the container.

We bend the special "tongue". It will close the hole on the front side.

We set the top lid of the container.

We close the top lid of the container in the lock.

We install the handle. The container is ready.

It is recommended to wrap the frame with honey in plastic wrap or apply shrink wrap in advance.